Microstructures and mechanical properties of friction stir welded additively manufactured Scalmalloy®

The development of high-strength advanced additively manufactured (AM) aluminum alloys is driven by the need for weight reduction in complex-shaped structural applications. In this context, heat-treatable aluminum-scandium alloy, known commercially as Scalmalloy®, offers high strength and lightness, also at high temperatures, due to solution strengthening Al3(Sc, Zr) particles. A widespread diffusion of such AM alloy is also related to welding technologies that could preserve its engineered microstructure. This study investigates the microstructural and mechanical properties of butt friction stir welding (FSW) joints of LPBF Scalmalloy® plates under different welding settings. Joint performance was evaluated under quasi-static and cyclic loading conditions. Porosity in Scalmalloy® and welds was assessed using 3D X-ray computed tomography. An aging heat treatment assessed the extent of precipitation hardening in the FSW joints. Results show that metal stirring during FSW notably reduced the intrinsic porosity of Scalmalloy®, decreasing the equivalent pore diameter from about 200 μm to 60 μm in the welded joints. Under quasi-static loading, welded specimens failed at the interface between the thermo-mechanically affected and the stir zones on the advancing side. The aging heat treatment improved the mechanical strength of Scalmalloy® from approximately 400 to 480 MPa, albeit at the expense of ductility (elongation at fracture decreased from 16 to 4%). The higher heat input and stirring developed at a low welding speed reduced lazy S defects but limited the effectiveness of subsequent aging. In fatigue testing, welded joints consistently failed within the aged base material due to the intrinsic porosity of Scalmalloy®.